A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.
Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
We're licensed and insured for residential and light commercial interior drainage work across Montrose, AL.
Most Montrose, AL inspection requests get a response within a day or two.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Every system is tested with a hose before we consider the install complete.
We scope every Interior Drainage System job in person before quoting it, since two properties with the same symptom rarely need the same fix.
We route the full perimeter or targeted sections depending on where moisture is actually entering, based on the inspection.
Every interior drain system needs a sump basin as its endpoint — we size the basin and pump to match the drain tile's expected inflow.
For finished basements where cutting the slab isn't practical, a baseboard channel system captures wall seepage without disturbing existing flooring.
We treat the cove joint as part of every interior drainage install, not as a separate add-on.
Existing drain tile that's clogged with silt or has failed slope can often be cleaned or repaired rather than fully replaced.
This helps us bring the right materials and estimate linear footage before the visit.
A technician checks where water is entering, measures the perimeter, and identifies the best sump basin location for discharge.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
Most residential interior drainage installs finish in one to three days depending on perimeter length.
"Water was coming in along one wall every heavy rain. They installed targeted drain tile just on that section instead of charging us for the whole perimeter."
— Montrose Homeowner
"Finished basement meant we couldn't cut the slab easily. Baseboard channel system worked great as an alternative."
— Montrose Customer
"They tested the system with a hose before calling it done, which gave us confidence it would actually work in a real storm."
— Montrose Homeowner
"Sump basin placement was smarter than what a previous contractor had proposed — shorter discharge run, less noise."
— Montrose Customer
Not always — if water is only entering along one wall, a targeted section can be enough, which we determine from inspection findings.
Drain tile requires cutting the slab; a baseboard channel is a lower-disruption alternative that captures wall seepage without floor demolition.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
An undersized basin cycles the pump too often, so we don't cut corners on sizing.
Cutting the slab does involve some disruption, but we work in sections and clean up debris as we go.
We give you a realistic timeline in the written quote based on your specific basement layout.
Not sure if your basement needs full perimeter drain tile or a targeted fix? Call +1-866-476-1348 and we'll walk through it.
Zip codes we serve in Montrose, AL: 36559
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
